DCAudioDIY.com

DC Area Audio DIYer's Community
It is currently March 28th, 2024, 9:33 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: September 12th, 2018, 8:01 am 
Offline
User avatar

Joined: December 14th, 2013, 2:19 pm
Posts: 948
1) Is blocking an issue with capacitor coupled cathode biased output stages?

2) Is there a way to DC couple a follower-type driver to an output grid in a self-inverting push pull output stage? See attached schematic. Please note that there is a cap upstream of the stopper resistor connected to the "upper" grid. BTW, the LM317HV is being replaced with a TL783. 700mA, 125V.

3)When using output tubes that require substantial grid current, is there another solution that can eliminate the coupling cap?
Respectfully,

Stuart

Attachment:
SIPP.PNG
SIPP.PNG [ 76.91 KiB | Viewed 6625 times ]


Top
 Profile  
 
PostPosted: September 12th, 2018, 2:36 pm 
Offline
Site Admin
User avatar

Joined: February 28th, 2013, 10:38 am
Posts: 1682
1) Shouldn’t be a problem unless you drive the output stage hard enough that it wants to pull grid current.

2) If what you’re trying to do is eliminate the unseen coupling cap on the upper output tube, two ways... 1: run a negative rail for the follower so it’s output is at 0Vdc. 2: use a resistor between the current source and ground to raise the cathode voltage on the output stage to follower DC output voltage. You’ll need to connect the lower output tube to the top of the added resistor, and you may want to increase B+ to get back to the desired operating conditions.

3) interstage transformer...

Roscoe

_________________
I can explain it to you, but I can’t understand it for you.


Top
 Profile  
 
PostPosted: September 12th, 2018, 7:37 pm 
Offline
User avatar

Joined: December 14th, 2013, 2:19 pm
Posts: 948
Thanks Roscoe. The interstage transformer did occur to me. I'm thinking probably the best choice, if I attempt to build this with a transmitter tube output. But I doubt that the 6SL7 can drive the transformer and provide the voltage swing. Current or voltage, for both without a lower Rp, higher current input tube. Or am I missing something simple?


Top
 Profile  
 
PostPosted: September 12th, 2018, 7:56 pm 
Offline
Site Admin
User avatar

Joined: February 28th, 2013, 10:38 am
Posts: 1682
No, you're not going to drive an IT with a 6SL7.... 5965....

Roscoe

_________________
I can explain it to you, but I can’t understand it for you.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 42 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group