DCAudioDIY.com http://dcaudiodiy.com/phpBB3/ |
|
Free Stereo Rack minus Threaded rods http://dcaudiodiy.com/phpBB3/viewtopic.php?f=7&t=939 |
Page 2 of 2 |
Author: | brombo [ December 12th, 2017, 5:01 pm ] |
Post subject: | Re: Free Stereo Rack minus Threaded rods |
Another way to insure stability is to have cylindrical spacers the length of distance between the shelves fit over the threaded rod (then 1/2 inch is fine and get the ordinary steel rod at Home Depot). The cylindrical spacers could be thick walled 2 inch pvc pipe (Home Depot again, sand off any lettering). You just need a way of making sure the end cuts are square. Not adjustable, but pvc pipe is cheap. |
Author: | Roscoe Primrose [ December 12th, 2017, 6:14 pm ] |
Post subject: | Re: Free Stereo Rack minus Threaded rods |
Pelliott321 wrote: Yes I am nuts!!!! That's a pre-requisite for joining this forum Roscoe |
Author: | chris1973 [ December 12th, 2017, 6:33 pm ] |
Post subject: | Re: Free Stereo Rack minus Threaded rods |
Pelliott321 wrote: I built this years ago when the flexi was the big thingy on the web I used 3/4 threaded rod from homeDepot and covered with black wiring harness stuff from auto store when you put a bolt both on top and bottom of shelves an tighten down its very stable. I grounded points on the bottom of the rods. Shelves are MDF hollowed out and filled with lead shot. Yes I am nuts!!!! "MASS LOADING", It works for speakers too, but has to be done a littler more judicicially. |
Author: | Roscoe Primrose [ December 13th, 2017, 10:32 am ] |
Post subject: | Re: Free Stereo Rack minus Threaded rods |
https://www.mscdirect.com/browse/tn/Cla ... readed+rod |
Author: | Pelliott321 [ December 13th, 2017, 11:56 am ] | ||
Post subject: | Re: Free Stereo Rack minus Threaded rods | ||
https://www.homedepot.com/p/Everbilt-3- ... /204276651 This is zinc coated but much cheaper. I needed more length so I used a coupler and added around 4 inches. Can always use paint but the cable harness looks good and probably adds some dampening. BTW only the two middle shelves are mass loaded. I used three rods/feet, but if would ever make another one I would use four. I do want correct some mistakes I made some day, but that project is way down the list. BTW that is a modified Lead Balloon under my TT (Sota Star Sapphire upgraded to Nova 23 years ago) This is an old picture, equipment has changed a bit. Logitech Touch is gone replaced by RPi3 server and the preamp in now a scratch build 6EW7 of Gary Dews design. The preamp pictured is now with Shashi being modded
|
Page 2 of 2 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |