Archival info on tone arm setup

[tomp]

I was going through some old papers and found a sheet that Mitchell cotter of the Varion step up transformer and Cotter turntable fame sent to Dick Sequerra. Dick sent me a copy many years ago. I scanned it and am including it in case anyone is interested. It may have been supplanted by now but it is interesting to see the hand drawings and charts.

Tom

Attachments

Mitch Cotter alignment instructions.pdf

(1.12 MiB) Downloaded 620 times

[SoundMods]

I have Mitch Cotters' transformer. But that was not his only claim to fame. His use of mil-spec cabling -- band-pass filters -- low-noise pre-amps -- mil-spec parts -- turntable isolation -- just to name a few.

He was ahead of his time and his designs are valid to this day.

[tomp]

I met Mitch several times at Dick's place when he was still in Long Island. Very knowledgeable guy.

Tom