DCAudioDIY.com
http://dcaudiodiy.com/phpBB3/

Interesting Links for Music and Equipment
http://dcaudiodiy.com/phpBB3/viewtopic.php?f=5&t=2267		 Page 1 of 1
Author:  brombo [ September 21st, 2023, 8:21 am ]
Post subject:  Interesting Links for Music and Equipment
I can across these links while browsing yesterday and thought some of you would find them interesting -

Audiophile music -

https://www.youtube.com/playlist?list=PL2KCwSR0Bdj4C0O4yTQwzo_UTvWuQpQkn

Building EXCEPTIONAL speakers using MODERN TECHNIQUES -

https://www.youtube.com/watch?v=XEspOD1NHr0

Making a £13000 turntable -

https://www.youtube.com/watch?v=vKFQ8B4cx64

I think the second link is the most relevant to this group.
Author:  tomp [ September 21st, 2023, 12:55 pm ]
Post subject:  Re: Interesting Links for Music and Equipment
Interesting video on the 3D printing. At the 2016 Speaker Design Competition, one of the engineering students who was an entrant used 3D printing to produce a speaker for his thesis. He doped the substrate with different types of fibers for the different sections to change the characteristics. The shape of the enclosures was also designed for each frequency range of the driver and had folds that added strength and rigidity. I'm including a photo.

Attachments:
MWAF Photo 14_small.jpg
MWAF Photo 14_small.jpg [ 157.16 KiB | Viewed 9819 times ]
Author:  Yeeterkeeter [ September 22nd, 2023, 8:41 pm ]
Post subject:  Re: Interesting Links for Music and Equipment
I thought that was a dalek from Dr. who
Author:  SoundMods [ September 22nd, 2023, 10:30 pm ]
Post subject:  Re: Interesting Links for Music and Equipment
tomp wrote:
Interesting video on the 3D printing. At the 2016 Speaker Design Competition, one of the engineering students who was an entrant used 3D printing to produce a speaker for his thesis. He doped the substrate with different types of fibers for the different sections to change the characteristics. The shape of the enclosures was also designed for each frequency range of the driver and had folds that added strength and rigidity. I'm including a photo.

This guy literally was thinking "outside the box." :thumbup:
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/