| DCAudioDIY.com http://dcaudiodiy.com/phpBB3/ |
|
| New AK4497 DAC project http://dcaudiodiy.com/phpBB3/viewtopic.php?f=4&t=919 |
Page 3 of 4 |
| Author: | HAL [ November 9th, 2017, 6:40 pm ] |
| Post subject: | Re: New AK4497 DAC project |
First mod to the stock board after listening will be to short out the 2 - 100uF coupling caps from the DAC. The DAC uses switched capacitor filters and has no DC offset. With the 49720 dual opamp, should be no need for the coupling caps. |
|
| Author: | SoundMods [ November 9th, 2017, 7:36 pm ] |
| Post subject: | Re: New AK4497 DAC project |
HAL wrote: No schematic? How can you guys apply a DIY device without a schematic? |
|
| Author: | HAL [ November 9th, 2017, 10:10 pm ] |
| Post subject: | Re: New AK4497 DAC project |
There is an output stage schematic and I2S Bus input diagram and AK4497 data sheet. All I need. |
|
| Author: | SoundMods [ November 10th, 2017, 10:06 am ] |
| Post subject: | Re: New AK4497 DAC project |
HAL wrote: There is an output stage schematic and I2S Bus input diagram and AK4497 data sheet. All I need. That's what I'd like to look at. Also, the number of the IC op-amp used in the output. |
|
| Author: | Cogito [ November 10th, 2017, 11:58 am ] |
| Post subject: | Re: New AK4497 DAC project |
HAL wrote: First mod to the stock board after listening will be to short out the 2 - 100uF coupling caps from the DAC. The DAC uses switched capacitor filters and has no DC offset. With the 49720 dual opamp, should be no need for the coupling caps. AK4497 chip itself is about $52 on Mouser. They are selling the finished DAC with all the bells and whistles for $116. Not financially feasible. Most likely all the components including the opamps are cheap Chinese imitations. |
|
| Author: | HAL [ November 10th, 2017, 6:49 pm ] |
| Post subject: | Re: New AK4497 DAC project |
As long as the pc board functions, getting a known AK4497EQ and better opamps since they are socketed. |
|
| Author: | HAL [ November 13th, 2017, 9:36 am ] |
| Post subject: | Re: New AK4497 DAC project |
Even the AK4490EQ board I have that was $26 has a $5 DAC ship in low quant. The chip price drops by half in quantity. The AK4497EQ in quantity is $44 at Digikey for a $118 board. Still may be fake or a second, so will see what happens. Now to get some power supplies resurrected. |
|
| Author: | Roscoe Primrose [ November 13th, 2017, 10:28 am ] |
| Post subject: | Re: New AK4497 DAC project |
There seem to be three different AK4497 boards available on e-bay. One of them uses two AK4497s, the other two only one. What made you pick this board over the other two? Shashi - Which one do you have? Roscoe |
|
| Author: | HAL [ November 13th, 2017, 11:10 am ] |
| Post subject: | Re: New AK4497 DAC project |
Roscoe, The one I have comes with the AK4497 installed. The others are boards close in price for dual AK4497's comes without the DAC chips. You have to buy and install them. Unless you can do SMD soldering, you have a non-working board. |
|
| Author: | Cogito [ November 13th, 2017, 11:22 am ] |
| Post subject: | Re: New AK4497 DAC project |
Roscoe Primrose wrote: There seem to be three different AK4497 boards available on e-bay. One of them uses two AK4497s, the other two only one. What made you pick this board over the other two? Shashi - Which one do you have? Roscoe I have the board from DIYINHK. I had the Chinese dual mono AK4495 DAC which failed with Burson mono opamps. To my ears, DIYINHK stereo AK4495 DAC sounded better than the ebay dual mono. I am going to stay away from Chinese DACs on eBay. Next spring I am planning to get into DIY dual mono AK4497 DAC. |
|
| Page 3 of 4 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|