DCAudioDIY.com http://dcaudiodiy.com/phpBB3/ |
|
USB Input for a CS8414 Receiver Chip http://dcaudiodiy.com/phpBB3/viewtopic.php?f=4&t=630 |
Page 2 of 2 |
Author: | Stuart Polansky [ May 26th, 2016, 9:19 am ] |
Post subject: | Re: USB Input for a CS8414 Receiver Chip |
Sorry Roscoe, I was writing while you posted. Took a look at the DF1704 datasheet. It couldn't be as simple as connecting pins 6 to 7 could it? XTI to XTO? In Lite's implementation, XTO has no connection. Stuart |
Author: | Roscoe Primrose [ May 26th, 2016, 9:26 am ] |
Post subject: | Re: USB Input for a CS8414 Receiver Chip |
Stuart Polansky wrote: Took a look at the DF1704 datasheet. It couldn't be as simple as connecting pins 6 to 7 could it? XTI to XTO? In Lite's implementation, XTO has no connection. Stuart No. Pin 6 needs a genuinely external; clock source, pin 7 is used to provide clock to other devices when the DF1704 is running on it's own internal clock. Needing to keep the SP/DIF & AES/EBU inputs increases the complexity quite a bit.... Roscoe |
Author: | HAL [ May 26th, 2016, 11:02 am ] |
Post subject: | Re: USB Input for a CS8414 Receiver Chip |
To get the I2S Bus working from the USB to I2S Bus board, you will need to disconnect the four lines going from the 8414 to the DF1704 filter and replace them with the ones from the board. Usually they are: SDATA BCLK LRCLK MCK And: Ground MCK becomes the XTI input on the filter chip. You will have to verify with the datasheet of the DF1704 that the clocking from the I2S Bus input is compatible with the USB board that is chosen. Look at the clock frequencies for each sample rate and verify that they are compatible. The DF1704 will not do DSD, so those outputs are left open on the USB board. The names for the lines on the Amanero board I listed are very similar to the board's naming. Hope that helps. |
Author: | Pelliott321 [ May 26th, 2016, 3:49 pm ] |
Post subject: | I am waiting for an Amanero board from Twisted Pear |
I have been building/using Twisted Pear Audio Buffalo DAC for a few years now, upgrading as they bring out new DACs I just ordered an Amanero board to add to my Bullalo SE The also have isolation and reclocking boards too http://www.twistedpearaudio.com/digital/amanero.aspx I will let you know how it works. I am not doing the isolation or reclocking yet |
Author: | HAL [ May 26th, 2016, 3:51 pm ] |
Post subject: | Re: USB Input for a CS8414 Receiver Chip |
The Amanero USB board sounds very good here with the TPA Opus DAC module. I ran the setup on batteries and sounded about the best of any DAC I had tried. HiRez on a budget! |
Author: | Pelliott321 [ May 28th, 2016, 7:10 am ] |
Post subject: | Re: USB Input for a CS8414 Receiver Chip |
There is also an isolator chip ISO7640fm that is mentioned on the Amanero site cost about $7 from digikey and you can get a free board from diythk |
Page 2 of 2 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |