A place to discuss member's DIY audio projects & post pictures/schematics. NOTE: There is a limit of 2MB per attachment, and a maximum of 3 attachments per message. If you need to post more than 3 attachments, just add another message.
October 30th, 2023, 12:51 pm
There is more to resistors than most believe or understand, and within a generic type not all are equals. When comes to audio projects resistors can make or ruin a project -or- at least create a mediocre end result.
Attached is a White Paper published by the February/1994 Audio Amateur issue that I recommend as a "must read."
Some of your know that I favor Vishay Bulk-film resistors (that are non-inductive) and wire-wound non-inductive bobbin resistors in the signal path -- both seem to "stay of the way" of good playback.
I believe the main reason is, instead of the snug-fitting end-cap connection of every metal-film resistor on this earth, the Vishay bulk-film resistors and bobbins have welded connecting-wires.
Additionally, both are non-inductive. Metal film resistors' elements are spiraled (like an ordinary inductor) around a ceramic, aluminum oxide, or glass substrate.
Carbon composition resistors have a compressed carbon/filler slug with the connecting wires simply inserted snug-fit into the slug.
May the Solder Force be with you!
- Attachments
-
- Resistor White Paper.pdf
- (1.9 MiB) Downloaded 1257 times
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.